Ceiling Fan Remote Not Working Light

If the remote light up on the camera viewfinder it is working perfectly.

Ceiling fan remote not working light.

One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. Flip the switch several times to make sure it is the right. This can usually be done by checking the dip switches. Should it become necessary to re sync the remote turn off the main power then turn it back on.

See the links below to go to the ceiling fan area for detailed photos and instructions. You can do this by pointing it towards the camera of your phone and then pressing and holding a button. Make sure the switch isn t in between positions. Check whether you have a faulty connection somewhere between the switch fan and circuit breaker.

If the ceiling fan and light works normally then the remote control module will need to be replaced. If no light is visible then it is busted. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. The battery in the remote control needs replacing.

In this case you will need to purchase a new remote and program it for the ceiling fan receiver. If the fan won t turn on and the lights are working then there is power to the fan. They need to be set the same way on both the fan and the remote. If you have an older ceiling fan the switch may be worn out.

Check whether you have loose ceiling fan wiring. Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds. The pull chain switches are in the wrong setting. Check to see whether you have loose switch wiring.

Follow the steps below to determine the cause. Confirm the reverse switch is not in a neutral position. Look inside of the light bulb socket to make sure there are no burn marks or charred spots. The fan will turn on and light if applicable will blink three times signaling a successful synchronization.

The light bulbs in the fixture are burnt out. Screw them into. Other conditions that may prevent a ceiling fan from working. If you are using a remote or.

Yes the ceiling fan remote control module may be faulty. A short or an overloaded circuit can cause the breaker to trip or turn off. Check the reversing switch. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high.