First clean out the holes carefully.
Causes warped wood siding.
When the ends of the boards expand against each other they warp.
The basic answer is that wood warps because of uneven drying rates within the wood fibers.
An improper maintenance schedule could be to blame for warped wood siding.
You might be able to repair some minor warping with nails and screws but this does not really address the problem.
When was the last time you had the house cleaned stained.
Moisture causes wood to expand.
Poor drainage can also cause problems and even sprinklers that constantly hit the side of a house can cause wood to become warped.
In 2008 new darker colors were introduced to the vinyl world and now two to three years laters these dark siding colors are buckling and warping due to heat attraction that they draw from direct sunlight.
Water damage can cause warped siding water exposure is a major issue with wood siding which is why so many homeowners prefer vinyl siding over wood siding.
Siding specialist such as findlay roofing can inspect your cement plank siding to determine the reason your siding appears warped and the best way to correct the problem.
Sometimes the actions of a homeowner can be the problem.
Using a bristle brush you should thoroughly clean out the hole.
Let me provide you with some.
Vinyl meanwhile is far more durable.
Sometimes holes in the wood siding are the reason for the siding being warped.
Some debris may have gathered in the holes.
If the siding was pushed upwards too tightly clamping very tight on the connecting lip of each siding segment below it might have encouraged stretching then warping and loosening due to subsequent heating.
If this is the case you can use stainable wood putty to fix these holes.
Termites will tunnel their way through wood as will powder post beetles severely limiting the protection your siding will offer.
Wood siding is particularly vulnerable to pests.
Additional causes for warped siding include structural issues such as missing studs improper nail placement or using the wrong nails during installation.
As my boards had sat there throughout the summer.
They range from woodpeckers searching for a meal to bugs and carpenter bees looking for refuge and sustenance.
Wood can only withstand so much of a beating from a combination of sun wind rain and snow before it starts to fall apart.
The reason siding becomes warped is because the ends of the wood boards were placed too close to each other when they were installed.
This is just something you cannot let go for too long otherwise it ends up costing you more in the long run.
